View Full Version : Liscense Plate Brackets
littlebandito
04-24-2006, 11:54 PM
I figured out that the brackets where the bolts screw in is whats causing my trunk to rattle with my subs. When I put pressure on them, the rattling stops so I guess I should secure em or ditch em. Anyone got some Ideas either way?
aleromod101
04-25-2006, 12:58 AM
Dynamat behind the license plate and I used like JB weld to hold my brackets in better cause mine were popping out when I went to tighten them. Used it and worked great I doubled layered my plate in the center area so it would have a better push to keep the license to rattle also what will be rattling is the piece where the alero piece is that whole piece will rattle. I took it off and dynamted the inside of it and nothing. But there you go man hope it works.
mikegett
04-25-2006, 04:44 PM
Good tip on the dynamat. I used the expanding foam on my plate. Unfortunately, I didn't realize that there are two types. I used the one that expanded twice as much and caused the pieces to bulge. Very nasty to remove and didn't save any time over the dynamat. Oh well, I learned.
coredump
04-26-2006, 04:17 PM
I took my plastic mounting bracket off completely, and got 2 more screws. I also got some thick rubber plumbing washers to put behind all 4 screw and just tightened everything up. No rattling from it now.
I still get some rattle in the trunk but at least its not the license plate doing it.
vBulletin v3.6.0, Copyright ©2000-2025, Jelsoft Enterprises Ltd.