Log in

View Full Version : Viper Alarm system problem


blackdog
09-26-2006, 08:14 PM
I have had my alarm installed for over a month and it has worked great. Last weekend I pressed some random buttons on my remote for the hell of it and now it wont chirp when I lock and unlock the doors. Also the LED light stays solid all the time. Anyone have any clue what is going on or how I could fix this?

Also when I use the remote it will still lock and unlock my doors and the lights flash on the front and back once or twice.

shackney
09-26-2006, 08:32 PM
read the manual!

AftermathAlero
09-27-2006, 02:15 AM
your in valet mode. You hit the button to activate it. Go get the manual and turn it off. I think its put the key in "Position" and push the valet button again to turn it off. (the hidden push button prolly on a trim panel or under dash)

blackdog
09-27-2006, 01:20 PM
I will try that. I had them leave the wireing up in the dash because I didnt want any holes put in the dash. As far as "reading the manual" I did this 5 times while at work and it only covers the basic controls like remote start, aux buttons, basic programing... As far as valet goes that is covered in the book and I will give it a shot. Thanks aftermath.

slowandlow
10-10-2006, 10:40 PM
open your door hit buttons 1 then 2 then 1 and you are out and you can do it agin to put it in like if you need the car serviced and you have the auto arm featue on