Log in

View Full Version : LEDs in PRND321?

Fi-Alero
11-25-2007, 05:07 PM
Does anyone know the best way to use LEDs for the PRND321 light? I can't figure out a way to hold the LEDs in place.
whiteliquid
11-25-2007, 05:40 PM
hot glue.....i have mine done.
cavaliers60
11-25-2007, 07:47 PM
What light is this??? lol
GoldStar611
11-25-2007, 07:56 PM
He's talking about the shifter :P
Spilner521
11-25-2007, 08:01 PM
Does anyone know the best way to use LEDs for the PRND321 light?
LED 194 bulb.
cherrington17
11-25-2007, 08:58 PM
I took the bulb out, epoxied the hole in, and drilled a hole for each LED under each letter.
YALEROYNOT
11-25-2007, 10:42 PM
any got picture of led shifter lights ?
cavaliers60
11-25-2007, 10:47 PM
All I did was pop in a 194 LED bulb. Works just fine.
Fi-Alero
11-26-2007, 05:55 PM
Hey chris, how did you hold all the LEDs in place under each one?
Silentalero
11-26-2007, 06:07 PM
All I did was pop in a 194 LED bulb. Works just fine.

exactly, do as told, use blue led and if needed shave dow the tip so the led isnt projecting the light to 1 spot.
AlbinoMonkeyRat
11-26-2007, 06:17 PM
hell, a blue bulb will do the job too, however, blue bulbs tend to fade to purple over time.

just remember 194.
cherrington17
11-26-2007, 07:02 PM
Hey chris, how did you hold all the LEDs in place under each one?

hot glue, on the inside. just take the prnd321 out (just clips in) and i put some glue in there. it helps spread the light more, and holds them in place.

just don't really layer it in there, then the prnd321 won't fit correctly.
YALEROYNOT
11-26-2007, 09:46 PM
two color leds blue normal and red when shifter is on that gear.
just a thought maybe when inm not working while out for my shoulder i will play with led and tis idea.

how to do it (maybe):
wire the red led in to dash selector glued into the back of the PRND321 console
blue 194 bulb backround

the leds are clear so the blue will show through when red is off.
jayson_waltz
11-26-2007, 10:05 PM
^nope the letters PRND321 by the shifter are acutllly blue from the factory with a clear 194 behind them, so red won't really show through right. But you can change them from the stock greenish to blue if you put blue led's where the 194 was. crappy pic below but ya get the point.
Fi-Alero
11-26-2007, 10:56 PM
Lol that 194 LED bulb sounds like a good idea. Where can i get one? Also, I really need a pic of what you are talking about chris.
strtrydr
12-02-2007, 12:21 PM
check out superbrightleds.com (http://www.superbrightleds.com) ... they got a bunch of LED supplies.
eag182
12-23-2007, 02:06 AM
I have a red led 194 and it shows through nice and red.
YALEROYNOT
12-23-2007, 06:21 AM
when i covered my center trim i elimnated (sp) them