Side Panels/Kick Panels help

[lovefrom1977]

With the panels that you take off when you run wires for an amp, how do you put them back on with the molding. Is the rubber molding supposed to go over it?

[lonnie]

With the panels that you take off when you run wires for an amp, how do you put them back on with the molding. Is the rubber molding supposed to go over it? You got to be kidding right? Just look at the other side and if that is tore up look up a picture. but everthing clips in and is pretty straight forward.

[Gr1m]

they are asking if the rubber goes ontop, which, yes it does to help keep mositure and water from getting in.

[lovefrom1977]

i have wires run on both sides so i couldn't look on the other side. How do you get the rubber to go over it because it goes like underneathmine and i can't really pull it out then.

[lovefrom1977]

Once i snap the plastic panel on the rubber pieces are underneath it so i can't pull it over. Does anyone have any advice?

[lovefrom1977]

could someone please help me with this?

[pimpalero2003]

just take the weather stripping off or get abutter knife and lift it up

[lovefrom1977]

you can put the weatherstrip back on once the plastic piece is on? and thank you.