View Full Version : power steering loss
my_hidden_romance
01-04-2008, 02:55 AM
my wifes alero has constantly had a power steering leak that went from being about a reservoir a week.. to being about one a day... i tryed to fill the tank with lucas oil and it wont hold... it gets bubbles in it and creates like a foam.. its got pressure but keeps leaking... the rack and pinion are all clear of drips and it seems to be comming from behind the drive belt somewhere near the upper belt.. where its impossible to see the bottom of the reservoir does anyone have a diagram of the power steering setup.. they make them for my acura but i havent been able to find a good manual for this car...
and if anyone has any tips for this let me know.. thanks...
YALEROYNOT
01-04-2008, 08:48 AM
it is the pump there is a weep hole behind the pulley. when the seal goes bad it leaks. i have replaced 2 of them on my car. if you are doing it get (borrow from auto parts store) a puller for the pulley. it is plastic and will brake if you dont use the puller.
my_hidden_romance
01-04-2008, 03:27 PM
sweetdeal project this weekend...:(... is there any way to upgrade that pulley to a metal one?? i have a few lying around from upgrading my s/c
YALEROYNOT
01-04-2008, 04:27 PM
sweetdeal project this weekend...:(... is there any way to upgrade that pulley to a metal one?? i have a few lying around from upgrading my s/c
don't know the first time i did it i broke the pulley and had to get a new one. the second one i got a puller and reused the pulley and broke the puller :lol:
Oldsman
01-04-2008, 09:12 PM
i just one on the wife's GA and it still did it after replacing the pump because it was leaking from where the sensor goes thru the pressure line into the pump. i think her problem is the internal cage pc is bad.
yes get puller from auto store and no there is no upgrade from plastic to steel on the pulley.
AftermathAlero
01-05-2008, 02:54 AM
sweetdeal project this weekend...:(... is there any way to upgrade that pulley to a metal one?? i have a few lying around from upgrading my s/c
If you do it yourself and break a pulley, i got one for sale. Its listed in the forsale section. For $14 shipped. Normally $25 bucks plus tax or shipping. Just to let you know.
my_hidden_romance
01-06-2008, 12:45 AM
i will keep you in mind.. soo far i havent touched the car wife didnt want me to get dirty... and i slept till like.. 4 cause i didnt get home and to bed till about 5 am..
my_hidden_romance
01-14-2008, 04:04 PM
found another leak in my system just above the back pipe for the exhaust the thermal cover seems to be blocking maybe a crack in the line... it sucks my tire slightly differ from each other in turnin cause the drivers side is dead stick but the pass has power minorly... so basically its hard to turn if the cars not rolling.
vBulletin v3.6.0, Copyright ©2000-2025, Jelsoft Enterprises Ltd.