Skulte rear wheel spacers.

[jabartram]

I ordered custom wheel spacers from skulte performance. here is the thread and pics.

http://www.nbodypower.com/nbodypower/showthread.php?p=2100&posted=1#post2100

[rustyballs_69]

How wide are they? They look to be about 3/4 of an inch.

[rustyballs_69]

I looked again and it looks over and inch actually?

[jabartram]

they are exactly 3/4.

[rustyballs_69]

Damn I was right the first time. It looks good with the wheel even with the fender.

[jabartram]

i have run into a small issue, my tires tend to rub the fenders going over some bumps, what is the best/safest way to roll my fenders?

[cherrington17]

um.. can we get pics linked here? not a member, can't view. (unless you want it kept that way... :ninja: )

[clutch1]

i have run into a small issue, my tires tend to rub the fenders going over some bumps, what is the best/safest way to roll my fenders?

Rent a roller from autozone.

Or get a wood bat and a jack, raise the car, stick it between the tire and fender, then lower and roll it forward and back... kinda ghetto but that's how I did it.

[Gr1m]

you could slot it and bend it then weld it on the inside

[jabartram]

um.. can we get pics linked here? not a member, can't view. (unless you want it kept that way... :ninja: )

all you have to do is join.

[jabartram]

you could slot it and bend it then weld it on the inside

i dont have a welder, and i dont want to destroy my paint. any easier options? the bat thing seems like a decent option.