Baggin' the Alero

[Fi-Alero]

I've been working on this for the last few days, so here is the build log.

First off, thanks goes out to StoopidAlero(this is his old equipment) and Richie. I would not be able to do this myself if they haven't been helping out.


Equipment:
Compressors: 2x Viair 380c
Tank: chrome 5 gallon
Struts: EasyStreet front and rear air struts for the Alero
Control system: ART Ridepro digital controller along with the remote system :D
Valves: ART Big Red 4-way

All of this pretty much took days of designing because I do not have much room to work with (you will see in the pics) lol

The valve block and sending units
http://forum.ecoustics.com/bbs/messages/4/533836.jpg

These are going in the spare tire well.
http://forum.ecoustics.com/bbs/messages/4/532369.jpg

My main problem was fitting my amps in with all of this. So I first built my amp rack, then I build my compressor/tank rack to slip over it.
http://forum.ecoustics.com/bbs/messages/4/532370.jpg

Here is the rack in the car, it will all get painted tomorrow.
http://forum.ecoustics.com/bbs/messages/4/532371.jpg

Drilled the holes for the compressors and tank.
http://forum.ecoustics.com/bbs/messages/4/533114.jpg

Put my spades on my connections. More pics of this will come.
http://forum.ecoustics.com/bbs/messages/4/533115.jpg

Here is the wiring. When I'm done, all the distro blocks and the relays will be neatly tucked in the area they are hanging out of.
http://forum.ecoustics.com/bbs/messages/4/533116.jpg

Got my amps power and speaker wire all set up in correct lengths.
http://forum.ecoustics.com/bbs/messages/4/533834.jpg
http://forum.ecoustics.com/bbs/messages/4/533835.jpg

And this is what it is going to look like when finished (except for paint and wire loom)
http://forum.ecoustics.com/bbs/messages/4/533117.jpg
http://forum.ecoustics.com/bbs/messages/4/533118.jpg

[cherrington17]

neat. now get to fiberglassin! :p

[clutch1]

And no pics of it dropped, major boner kill!

Lol jk, looks sweet so far mang, can't wait to see the outcome.

[deathwish666]

mmm thats sex...

[AftermathAlero]

looking good bro!

[darksobsession]

that's a sweet setup!

[Silentalero]

those amps are gonna sufficate in that small area, aside from that its lookin good

[Fi-Alero]

I got alot of progress made in the last 2 days :D
I finished the rear yesterday, and I hope to finish the front by thursday.

For now, here is a teaser pic of the back laid out. Sorry, I took it with my phone at work lol.
http://forum.ecoustics.com/bbs/messages/4/534832.jpg

[cherrington17]

nice job

[02Alero]

looks good

[lonnie]

looking good x2 on those amps getting air

[Fi-Alero]

Thanks for the feedback guys.

The amps will be fine lol. Got an inch above the below the amps. They are both being ran @ .5ohm, and have never got hot before lol.

[01OldsAleroGt]

hittin them switches on the bags... hell yea man.. props on ya.. get some pics of the ride when you have the suspension done

[Trickyslick]

Looks like on beautiful car....

[MattismodderX]

i demand some high quality photos that alero looks sexxy

[Fi-Alero]

Lol thanks guys :)

I will have some high quality photos up once I get the rest of the bags on and my calipers painted. (hopefully this weekend)