couple razzi kit questions

[whiterider00]

first, for those of you who have the razzi kit, approximately how much does the kit extend down from the stock bumpers and rocker panel moldings. my car is already lowered on sprint springs and im just hoping its not gonna be too low for some of the roads around here. secondly, can anyone with a white 4 door alero and the razzi kit post up a pic. on this site, cardomain, and google, i havent been able to find any pics of a white one. thanks

[DansGen1Alero]

the front bumper no extension, the rear maybe an inch or 2. Sides (its been a while) but i think most 2 inchs. You shouldnt have anything to worry about with a lowered car....unless its like 3 inchs. i have eibach pro which is 1.3 and 1.4 and no problems.

sorry cant help u with the white pic, mine is aurburn mist

[Kilroy]

Not to thread jack, but this is STILL a Razzi question. Now, I understand the Razzi front bumper is designed to go overtop of the original bumper. now, if there where say a chunk of the original bumper missing, say about just less than a foot of the front right corner, could you get away with still installing the Razzi front bumper?? Wondering if I should go Razzi, or just get a new bumper!!

[DansGen1Alero]

if its below the indentation of the bumper then yes. a picture would help to tell tho

[Kilroy]

if its below the indentation of the bumper then yes. a picture would help to tell tho

I'll try to get one up tomorrow. Thanks Dan

[worknprog.99]

so the razzi kit trully is an add on bumper to the factory that uses the bottom clips of the bumper causeing there to be 2 creases in the bumpers...

razzi doesnt make a full bumper ?

[whiterider00]

nope. goes over the stock bumper covers. so ya, there is a little bump from the edge of it right at the bottom of the indent we already have. never seen one in person, but all the pics ive seen it doesnt look too bad.