View Full Version : firewall grommet where pcm wires are help :/
irondiezl3
01-03-2011, 02:34 PM
i ran my power wire through the rubber grommet where the wires to the pcm go. i got it through but the grommet came lose and now i cant get it back into place. the rubber is so thick and hard i cant get enough force to flex it back into the firewall hole any tips tricks ideas?
cavaliers60
01-03-2011, 02:51 PM
use a screw driver to help push small sections of it back in? Might work.
cherrington17
01-03-2011, 02:53 PM
push harder. thats really all there is to it...
irondiezl3
01-03-2011, 03:34 PM
harder did it lots of elbow grease man those r so tight.
cherrington17
01-03-2011, 03:38 PM
harder did it lots of elbow grease man those r so tight.
...for a reason....
irondiezl3
01-03-2011, 04:10 PM
random question my headunit has a option to turn the amp inside it off. with that i dont have to disconnect the wires on the radio harness for the speakers do i since i was going to run new speaker wire from the amp im installing straight to the speakers themselves. also my amp has 2 30 amp fuses in it so i need a 60 amp in my power wire fuse right? the amp kit came with a 150 but i think thats too much.
Cliff8928
01-04-2011, 01:28 AM
i ran my power wire through the rubber grommet where the wires to the pcm go. i got it through but the grommet came lose and now i cant get it back into place. the rubber is so thick and hard i cant get enough force to flex it back into the firewall hole any tips tricks ideas?
Acutally, you pull the black part out of the grey part... Then you re-seat the grommet to the firewall.. Then re-install the black part.
vBulletin v3.6.0, Copyright ©2000-2025, Jelsoft Enterprises Ltd.