Gauge pod assembly

[Papa Rad17]

Well I just got don't installing my gauge overlays but in the process and through my stupidity completely broke and then had to tear off the entire plastic cover. Now of course one could reach in there all the way to the needels ( I'm not stupid enough to do) but my concern is debris and air movemt around them. Should I be looking for new cover or it no big deal?

[sleepyalero]

Gauge cluster. Not gauge pod.

Gauge pod goes on the a pillar or in other areas its custom made for to hold aftermarket gauges. ;)

Just go to a junk yard and replace it. I don't think its a big deal..

[Papa Rad17]

I'm not best with car terms most ofthe time lol. My only concern is that a junk yard will want to sell the whole assembly which I don't don't want to have to get the whole deal. I think it will be fin but around 50-70 mph if the air get flowing just right whith the windows down the needle will bOunce around a bit but I don't think it'll be a vary big issue.

[sleepyalero]

no you should be able to rip it apart and buy certain parts.