rear door speakers!

[Papa Rad17]

I thought i had it all worked out anyway... i got everything pulled apart and was about to run the wires through to the door... I quickly discovered that there is a plug there:eek:with no effing way into that rubber hose to get the wires to the door. luckly I hadnt starting cutting the panels yet, Im going to leave it tore apart until tomorrow, if I cant dream something up then I'll have a set of rockford frostgate 5 1/2's up for sale. SO, anyone have any ideas for getting another set of wires into the rear doors?

[jhubbz]

Not all pins are used in plugs like that. Idk what it looks like, but I would take a look at it, if you have some empty ones, you could drill a small hole there

[Ryan from Ohio]

Head out the the junk yard and get two of the grommets with the connector tubes from some other car. Drill holes, install and run wire.

or...

http://www.jcwhitney.com/painless-universal-door-jamb-switch/p3065031.jcwx?skuId=2370793&filterid=u0j1

Maybe something like this will work...

[Papa Rad17]

I was actually thinking about drilling new holes in the door and center beam, put a rubber grommet around them, run wires, silicone them in place. I had though about trying to get through that plug, there's no way, when if I could I couldn't get through the hose to the door for crap.

[Ryan from Ohio]

You wouldnt want to silicone them in place.

You want an oversized grommet to allow the wire to float. This helps reduce how much if any it bends.

[Papa Rad17]

Im abandoning the plan. :(

[kwhauck]

hmmmm.....I tried to find something, but I can't even find my rear doors!!

[Hellfire5670]

Make a few extra holes and put grommets and run wires through Would take about 10 mins

[jawa]

there is always a way, when i come down there ill look at it for ya

[Hellfire5670]

If i was closer i would come and do it for you for a few beers :P

[Papa Rad17]

Doing that was mentioned^ up there...