View Full Version : how to remove projector from foglight
i4g3t
02-14-2013, 02:00 PM
does anyone know how to remove the projector from the foglight housing? i just picked up a set and there was water inside it. so i figured id take it apart and paint the foglight housing surrounding the projector. figured id ask for help before i go ahead and end up breaking it lol
sleepyalero
02-14-2013, 02:08 PM
I did it once but it was a long time ago. I believe you have to break it but I'm not sure. Just tape it off and do it. Easier then actually trying to pull it apart.
i4g3t
02-14-2013, 02:29 PM
ok i guess ill have to give it a try lol. im going to finish putting leds in my hvac first so itll give me time to figure out how i want to do it..
sleepyalero
02-14-2013, 02:38 PM
Sounds good. Andysautosport used to sell the fogs with the projector tinted black, I think they still have them. 40$ a light.
tw0123
02-14-2013, 06:56 PM
Iirc a flat head screwdriver and some patience will get it apart... i think it is spring loaded into the levelling mechanism so you have to be patient and remember how it goes together... there might be a couple plastic screws in there too... as sleepy it's been a while since i did this... didn't break it though... i remember that much cuz i was going to sell them to mike the canadian for his malibu!!
sleepyalero
02-14-2013, 08:58 PM
Maybe it won't break, it's been so long and I no longer have stock fog lights lol
i4g3t
02-16-2013, 06:26 AM
i tried it on the one i cut the one of the clips off that hold the projector in, i still had to work it out. ill just epoxy it back in or something lol but now i see how there held in. worst case ill just go to the jy and pick up another one
sleepyalero
02-16-2013, 08:43 AM
Good luck finding one that isn't cracked and will take in water quickly.
vBulletin v3.6.0, Copyright ©2000-2025, Jelsoft Enterprises Ltd.