New Hub Assemblies installed

[Garnetdawn]

Just installed both right and left front hub assemblies :D. Easier then i thought it would be other then getting a 36 mm Axle nut socket and a torch other then that it was a breeze. If anyone has a question about how to replace them feel free to ask.:coolio:

[mfuller]

Which brand did you use?

[a.graham52]

What on earth did u use the flaming hammer for ?

[rocketfast321]

Which brand did you use?

I used Timken

[Garnetdawn]

I went with pretty much OEM replacement off ebay seller was detroitaxle.....yes a torch a hammer and the end result a smell that smelled like musty ass crack

[a.graham52]

What on earth did u use the flaming hammer for ?

I must ask again... What on earth did u use a flaming hammer for?

[[ion] C2]

probably to loosen the axle nut because i'm assuming he has no impact gun

If so, next time use a good penetrant and an impact/lots of elbow grease. Not the best idea to custom heat treat stuff on the car, lol.

[Garnetdawn]

C2;652603']probably to loosen the axle nut because i'm assuming he has no impact gun

If so, next time use a good penetrant and an impact/lots of elbow grease. Not the best idea to custom heat treat stuff on the car, lol.
Ahemmm..In fact your wrong it was used to break the 3 bolts that hold the hub asembily to the axle considering they were in the original Hubs for 13 years. The axle nut broke free the first try and I did in fact have a Impact gun

[Garnetdawn]

And yes man I used about 3/4 of a can of penetrant