Help With Setting Up Lilliput Touchscreen

[wy3134]

I am trying to finally get my setup going. I just purchased a new Lilliput touchscreen, but I dont know how to get the touchscreen aspect working. any advice or steps on how to do this would be greatly appreciated. Thanks!!

[FormulaNERD]

make sure the usb is connected and functioning, and all applicable software/drivers are installed.

[wy3134]

theres no seperate usb cord coming from the screen other than the 8 pin plug.... and the multiple inputs usb plug...????

[FormulaNERD]

i'm not sure... i just know that the touch feature it's self uses a usb cable and a mouse like controller to pinpoint where you're touching.

[wy3134]

Do i possibly have to open the unit up, cut some wires off the 8pin wire and connect those to a USB cord? I just realized thats what was done on this other touchscreen I have....anyone have any ideas?

[FormulaNERD]

hmmm, i'd ask aleromaster... or the person you got the first screen from (if it isnt him) i think that phil (voodoosoup) also had one....

[Voodosoup]

Here's a picture of the cable that hooks up to the 8 pin coming off of the Lilliput screen that I have. I has a VGA connector and coming out of that is the USB cable for the touchscreen.

[wy3134]

yea thanks! i just figured it out this morning, LMAO like dumbass what else would that USB cord be for! thanks for the help guys! ill get some pics up later when i get the install complete today

[Aleromaster]

Just so you know the one you bought from me was setup like that becasue the controler board craped out on me so I replaced it and had to make a few changes for the radio mount mod.

[wy3134]

ahh ok...thanks for the clarification on the setup there