Engine Wire Loom Stuff

[elitecloud]

ok so i bought some of this red loom stuff off ebay, and i want to put it in my car, but i don't know what wires i should loom...which ones will melt if i try putting it on and it getting to hot....

so i was hoping someone could perhaps snap a good picture of thier engine bay if they have it done already to give me a place to start and a reference when i start looming the wires...

p.s. i've checked cardomain and here for about an hour for some pictures no luck


Thanks :beerchug:

[eag182]

I think -Alero- 's yer man

[jabartram]

here you go.



[attachmentid=6954]

[elitecloud]

ok thanks guys...

i printed out the pictures and used them as a reference :) tho due to time constraints and loss of sunlight i could only do so much snifflecakes..

Before
http://img99.echo.cx/img99/8581/7241408115733006lx.jpg


Layout of equipment and stuff....
http://img99.echo.cx/img99/5578/7241422899733007pg.jpg


After, Horrible picture because it was dark and stuff i'll take another picture later :)
http://img99.echo.cx/img99/4929/7241436006933000hg.jpg

[jabartram]

looks good its a start!

[jabartram]

another shot


[attachmentid=6955]

[jabartram]

one more

[BlackJack]

Looks nice both of ya....
jabartram, where'd ya get the colored cable housings?

[jabartram]

Originally posted by BlackJack@May 27 2005, 08:16 PM
Looks nice both of ya....
jabartram, where'd ya get the colored cable housings?
Quoted post



it's loom.

[elitecloud]

you had loom big enough to wrap around the radiator hoses? mine did but wasn't very snug enough to look good......

edit : where can i get some red spark plug wires..thanks

[jabartram]

^^^ msd is usually red. depends on the company you buy from.

[Kurt Zee]

does anybody know if the have white s.p. cables? i'm getting the white loom...i know it will get dirty...but i'm gunna be washing it a lot.

[jabartram]

^^^ not as far as i've ever seen, just loom them, and white under the hood isn't to bad, i had an 82 mustang, the motor was the same white the outside of the car was with polished aluminum valve covers and such, actually looked very good, and very bright under the hood.

[Monster189lb56]

what material is the loom made out of?
:blush:

[jabartram]

heat resistant plastic.

[-Alero-]

Originally posted by elitecloud@May 27 2005, 10:08 PM

Layout of equipment and stuff....
http://img99.echo.cx/img99/5578/7241422899733007pg.jpg


Quoted post




hey i see my car in there! yay! :beerchug: