Help on wiring subs
 

Hi. i have a question for anyone who knows stuff about subs. i have 3 12" alpine Type e's that i put in a box for three and i want to connect it to one or 2 300 watt amps. how would i do the wiring for that. If not, how can i wire the 3 subs to a 2 channel 1000watt amp? have a diagram i foud but im not sure if its correct. any help? thanks! http://www.crutchfield.com/learningc...2Dohm%5Fmo no

basically what you will need to do is figure out what the impedence is for your subs and if they are single or dual voice coil. Then figure out the lowest ohm rating is for your amp. From there.. you can basically get online and find a diagram that will specifically tell you how to wire your subs ( series or parallel.) I would have to check but im pretty sure there is a site where you can just put all your info into a calculator and it will give you the impedence and wiring suggestions.

www.rockfordfosgate.com

they have a wiring diagram on there in the support part. good luck