sterio trim
 

hello everyone...

this is a stupid question i had my sterio out 2 years ago and now i dont remember hou to take off the trim to get to the sterio ... the trim loosened up and just need to get it put back in place so i have no gaps for stuff to fall into.....can anyone help

you're trying to get the trim off? ... it should just pop right out- its held in place by clips.. take a flathead screwdriver and GENTLY but firmly pry it away from the dash and it should pop out-

(im not responsible for any trim broken or damaged during this process) lol

is it the same if you have a middle consol

:blink: might try explaining that one a bit more-

i was wondering if you have a center console if you can pry the trim off with a screw driver like you would if there was no center console

LOL.. either i'm completely retarded or your posts aren't making any sense to me.. or a little of both? :blink:

are you trying to put the trim back on.. or take the trim off to remove the stereo or head unit?

or better yet.. post a picture of what you're trying to do :lol:

ok i figured it out how to get the trim off,,,,

ok i got an after market sterio installed and when the trim locks in place i can get the side clips to locked in all the way but the top 2 clips will not lock in place all the way to where there is about 1/4 to 1/2 inch gap.

they had to install the after market sterio installation kit so either the trip is hitting on the plastic installation kit or the installation kit is to tall for the factory trip

find out where the two are making contact? take pictures if possible?

i had to flie a bit of room around my aftermarket stereo trim so the dash trim would fit tight.

these are the pictures been a while since i up loaded thru here see if i remember how to do this

holy crap- it sticks out that far? :lol:

it looks to me like it would be able to fit around the head unit- it fit around mine without any problems- did you get the right head unit installation kit?

what you -might- have to do.. is take the head unit's trim off.. to get the console trim to fit around it.. try that and take pics-

im gonna be gone for the next half hour or so.. gotta finish up around here at work and head to the house.. so BBL!

best buy installed if for me a couple of years ago...... no it dont stick out that far but for some reason i cant get the top 2 clips to fully lock in place ....i dont really want to have to cut any of the installation kit but i dont know what else i can do i even pushed on it with the back end of a long screw driver but no luck yet

heres what it looks like locked in place

thinking about breaking out the dremel and cut a little bit off of the edges and maybe a little off the top

looks like it will fit, mine was tight to begin with too. just put the clips in and hit it with your fist to lock them in (i am not responsible for damages, i've tore so many trim pieces off i'm used to hitting them back on)

That's exactly what I do. The ones on the floor by the doors are terrible. One of mine had a rusted clip that fell off. JUst hit the thing make sure there isnt too much around the bottom so it doesn't bend or crack.