Massive Audio CK6 Stage III Comps
 

These aint mine obviously! lol

Somewhat of a review, based off appearance.

Mids:

The material used is nice. The machining on the mid bass baskets was a nice touch! Looks well put together, no glue slop, nothing looked out of place. The tinsel lead connection point was decent. The spade terminals are mounted on a nice piece of composite material. The carbon weave cone was done in agood manner- it was very consistent and uniform.

Tweets:

The tweets are some beasts! Again like the mids they were clean and crisp- no sloppy glue. The outter case was clean plastic, was a good mold job. They are a little on the deep side as seen in the pics.

Crossovers:

Appear to be very similar to MB Quarts.

Packaging:

Obviously they put some money into the packaging. They come in a nice case that appears to be carbon fiber. Its not a sticker, just some sort of a cloth I guess... Very nice display.

Since these aint mine I cant use them and right now I dont have any means to test them anyhow. After having a look at them I would consider using something like this in my car.

Have a look at the pics:

damn those look good

I honestly think I will be putting a set of these into my car, when I can afford to.

price range
Are things available seperatly

Those are very nice components. I've always been a fan of Massive Audio.

I just wish they could handle a bit more power :(

About $170ish shipped- providing my price remains same. Separately like how? lol its a set, therefore the components are all matched together. I dont have any listings for the items listed separately though.




I dont think 130 WRMS is to terrible. Providing they can handle and make good use of the power, eh :)

Yeah, If you are going to run a nice component set like that tho, it's always good to go active. The passive crossover steals so much power. I run 300rms per side in my car and it screams :D

Yes active is the way, if you can do it.

For most people skill set the passive way is best.

:ninja:

300? that's alot of wattage.

I go for Quality, Not Quantity.

I am going to be dumb here and ask this; when you say you run the 300 rms, without the passive crossover, does that mean you just run your power direct from your amp(s) to your component sets?

^Yes, but in order to do so you DO need some sort of a crossover. In his case you will use a 3 way crossover that allows you to "bandpass" the mids and a tweeter. You filter the signal at the RCAs source before amplification. Using the passive crossovers you are filtering it after the signal has been amplified.

Believe me, the quality is amazing too lol.

Ryan is correct. My crossovers are set at the radio.