OK my G/F's brother helped me put in the volts and a/f I put in the EGT today.

a/f isn't hooked up yet, I'm buying the pigtail from PFYC when I buy new brake pads. I'll be putting it though the firewall later this week, along with the EGT probe.

close up of the EGT. Love that range :thumbsup:

oooooo

ahhhhh

looks great man :thumbsup:

i am having a stupid moment though, what is EGT?

real nice :thumbsup:

EGT Exhaust Gauge Temp.

It's cool I didn't know either until I researched it

actually with the EGT you don't need the a/f gauge. the EGT is a lot better.

looks good, redog.

those look sweet...nice job

that looks so hitech, where is it from, was it hard to install, how much did it cost, How much do the guages cost? i'm runnin outta interior mods to do. thanx

Very nice man!!!!

Those bezels look great!

Looks good.

Looks good man

nice man, i like those, nice touch with the red rings too..

i love em

but i'd still feel tacky riding around with em

heh

D'ohh (smacks head)



I got the a/f from Nopi.com and the EGT from Summitracing.com. The install was easier than I though.

I followed the directions on PFYC.com for the pillar install. Then I just ran the wires though the holes in the pod, down the bottom of the pod and over the panel above the pedals to the radio. (Panel comes out real easy. The left panel has a push pin and the right one has 3 7mm bolts)

Hooked up to the wires up to radio hardness. The brown wire is to the lighting, and the yellow is the ingtion wire. These wires are on the right side of the hardness. There is another set of brown and yellow on the left side of the radio but they are speaker wires.

Thanks y'all :thumbsup:

i didnt use a pigtail for my A/F(got the same one). i just tapped in and soldered my wire straight to the upstream sensor.

they look awesome redog...nice job