Quote:
Originally Posted by Ryan from Ohio
Ok...
Pint Source: Sound emitting from one location R/L
When you place the tweeter in the sail of A pillar and the mid down low in the door what happens to your point source?
To overcome this you need to attenuate the tweeter. Otherwise you can pick out where the tweeter is and where the mid is.
Placing the tweeter close to the mid creates a good point source. Coaxs are obviously a good point source.
So before you mount your tweeters up high permanent, play around with the placement some. Use double sided tape. Get a comp set that has adjust ability. Not all do.
|
yes i understand that, but my point was ease of install using the stock locations. i dont want to cut new holes in my doors, so i use the factory spots, in the rear i have my mids and tweeters sitting within 1 inch of each other.