Of course it'll fit. They do it in the Ecotecs, it's not that much bigger. Someone is shipping out a hacked off MP45 manifold to me Friday. AKA the same manifold the MP45 supercharger uses, just with the supercharger area cut off, so all I need to do is get the metalshop to weld up a box with the correctly spaced threaded holes to strap this thing onto, spaced to line up the pulley with the belt. And put a barb fitting on each side, one for the FPR/boost gauge, and one for the MAP sensor or whatnot.
This one will be easy to make, it's the mass-produced one (using just the 2.4L flange that's readily available) that's going to take some customization, since I'd have to have the shop design the runners from scratch and make a whole new box, with everything sized right.
Here's a shot of one of the j-body guys' progress, who later dropped off the face of the earth, like the other four who were supposed to make it since 2005.
