[AlbinoMonkeyRat]

driver seat does come out the same way, BUT if you have the power seat, you have to be careful not to yank the wire out of the motors. the wire is kinda weak. it is clipped on though, so if you unclip it before you move the seat, you'll be golden.

as for the rear seat, the bench simply clips in...just give it a good tug and it will come right up. PULL IN THE UPWARDS DIRECTION
the fold down backs are held in with spring-loaded "clamps" which are easier to get out with the seats folded down, and use of a flathead screwdriver to open the clamps. These clamps are located in the middle, where the backs meet.
the side cushions...I'm not sure how the 2-doors are (maybe the same???) but on 4-doors, they are held in with one bolt each (maybe 2??? it's been a while since I've taken them out).

so all in all, the only tools you need is a wrench and a flathead screwdriver. Should be able to get them out in a half-hour for your first time, and within 5 minutes any other time after that, if you remember how you did it.