|
The bottom coilpacks need a long extension a wobble joint and a deep well socket. The alt is fine, just hold the bottom nut while taking the top one off so you can remove the wire. Be sure to slip the cover back over it when it is off since it is still hot if the battery is hooked up. There is no such thing as a "pushrod puller" you simply unbolt the rockers and remove the pushrods, make sure not to mix them up or you will trash your motor. The rockers can be mixed and matched so you can just throw them in a pile. The tab on the pedastal of the rockers makes them self aligning, all you need to do is torque them to the proper spec and preload. Which I believe is 18 ft/lbs + 90 degrees but I may be wrong so check that before you use it. I dont have my haynes manual with me to find out for sure. Hope that is what you were looking for.
|