1. Wet sand tails with 2000 grit wet sand paper.
2. Wipe clean with alcohol.
3. Three coats of vht, 5 minutes between even coats. (Would not suggest more than three)
4. Allow 15 minutes dry time.
5. Four to five coats of clear. (gloss)
6. Wet sand again with 2000 grits wet sand paper.
7. Get some buffing supplies. ( I used McGuire's Ultimate Compound, wal-mart) Cover entire tail then rub vigorously until all of it appears to be rubbed in.
8. Wipe off excess, if any with a microfiber towel.
Do not try to tint your headlights. Just use regular spray paint on your bezels if you do so choose to paint them if you tear the assembly apart.
Good Luck!
Bezel:
Tails:
Ignore the wing. What a ricer...