Aleromod.com - View Single Post - Accidently pulled out the driver-side output shaft on transmission.

Robb235 · 08-22-2010, 01:32 PM

A little update:

A few whacks with a heavy hammer and the cv axle disconnected from the output/intermediate/center shaft (I've heard this thing called three different names, lol). I found the snap ring that was holding it into the transmission; it was laying on the ground, broken in a couple pieces. I can pop it in and out of the transmission ok. I just need to find a snap ring to replace the broken one so it will stayy inside the transmission. The snap ring on the other side of the shaft that holds the cv axle on is ok.

08-22-2010, 01:32 PM	#24
Robb235 GX Member Join Date: Aug 2010 Location: Chattanooga, TN Posts: 14	A little update: A few whacks with a heavy hammer and the cv axle disconnected from the output/intermediate/center shaft (I've heard this thing called three different names, lol). I found the snap ring that was holding it into the transmission; it was laying on the ground, broken in a couple pieces. I can pop it in and out of the transmission ok. I just need to find a snap ring to replace the broken one so it will stayy inside the transmission. The snap ring on the other side of the shaft that holds the cv axle on is ok. __________________ '95 Monte Carlo 3100 2003 Yamaha YZF-R6 2001 Alero (wrecked, rebuild in progress)