Quote:
Originally Posted by [ion] C2
I measured today, looks like 1.1 inches would be ideal.
I forget what the back side of my wheels look like, but they're dual 5 lug bolt pattern.. the way I'm thinking, they won't work. I mean if the other 5 lug pattern doesn't line up with the stock lugs.. it won't clear with the spacers on either.
I guess I'll have to take a wheel off and look, and measure 1.1" from the car's hub and see how much stud will be exposed and see if it will clear the wheel.
|
you could still use your wheels and spacers... they make them where you can switch the bolt pattern on the new studs, get the spacers that adapt from 5x114.3 to 5x100 and use that bolt pattern on your wheels then the original 5x114.3 will fit into the backspacing on the wheels... might cost a bit more, or again just shave the original studs down to sit flush...
__________________
Misty: 3400, S&S headers, TCE 65mm TB, CAI, 180* TStat, Milzy motor & tranny mount, 18" BOSS 328 & much more... going osv!!
Silver: 2.4L, 5 speed, GAGT seats, front & rear STB's, all red tails, led headlights, Magnaflow muffler, Milzy Motor mount, WAI, Cosmo short shifter; sold n missed  
Tequila: 2.4L, GA interior swap, scrapped...
|