Aleromod.com - View Single Post

MMGT1 · 07-24-2011, 03:40 PM

WB is good for PE mode. I use NB to tune low end because our PCM will move trims as soon as NB is back in. Then the couple of % you are off in difference between the NB and WB gets carried into PE mode. NB is actually very effective at 14.7:1, or whatever it is reading 1 lambda at.
I should add though, this is if you are going to use your NB. If you are leaving the WB in place as a perminant install, then yes, no need for trim tuning like that.

07-24-2011, 03:40 PM	#9
MMGT1 GLS member Join Date: Jun 2011 Location: Canada Posts: 1,319	WB is good for PE mode. I use NB to tune low end because our PCM will move trims as soon as NB is back in. Then the couple of % you are off in difference between the NB and WB gets carried into PE mode. NB is actually very effective at 14.7:1, or whatever it is reading 1 lambda at. I should add though, this is if you are going to use your NB. If you are leaving the WB in place as a perminant install, then yes, no need for trim tuning like that. __________________ A SS looks like it could kick your ass if it wanted to, but a WS6 looks like it's coming over to do it Last edited by MMGT1 : 07-24-2011 at 03:52 PM.