Aleromod.com - View Single Post - How hard is it to change the master cylinder and the slave cylinder

jcs_blizzard · 09-13-2011, 08:35 PM

I was driving my car home last night and heard a pop coming from around my clutch pedal. when I turned off my car and went to start it again my clutch pedal was all the way down to the floor... I was able to pull it up by hand but it no longer does its job. I was able to drive my car home without so i know my clutch is fine. My guess is it the master cylinder and or my slave cylinder. Do i have to pull the tranny to get to them or are the behind the engine by the fire wall. Thanks!!!!

09-13-2011, 08:35 PM	#1
jcs_blizzard GX Member Join Date: May 2008 Location: Yellowknife, NT Posts: 2	How hard is it to change the clutch master cylinder and the slave cylinder I was driving my car home last night and heard a pop coming from around my clutch pedal. when I turned off my car and went to start it again my clutch pedal was all the way down to the floor... I was able to pull it up by hand but it no longer does its job. I was able to drive my car home without so i know my clutch is fine. My guess is it the master cylinder and or my slave cylinder. Do i have to pull the tranny to get to them or are the behind the engine by the fire wall. Thanks!!!! Last edited by jcs_blizzard : 09-13-2011 at 08:58 PM.