[XanderWiFi]

I'll look into those but I don't think I'll be doing much custom fabricating. I do have LED questions but I am going to look on another thread or make one more directed to the question.

Put a blue LED bulb where the stock cubby bulb is. Problem I have is I only had about 3/4 inch of wire to connect to and when I went to strip it I accident pulled the entire coating of plastic off that little bit of wire. Soldered, covered in electrical tape but the bulb will go out with too much movement this way or that. I am thinking it is being grounded out with the entire covering being pulled off? Remedies or tricks to such a thing?