[r53silver91s]

Installing the Borla was eazy, its a direct bolt on so all you gotta do is take the old one off, you'll have to cut it though to get it off (well at least I did), and then put on the new one.

Well now that I'm thinking about it we had to use a blow torch on the bolts that connect to the cat cause they were all rusted out and wouldn't budge.

And I have the borla for a grand am so we had to cut out some of my bumper cover only because I got hit on the rear pass. side and my reinforcement bar was crushed so it caused the exhaust on that side to sit higher and back a little farther than normal. I don't know if everyone has to cut theirs or not.

Install should be the same with the SLP, but somebody with that exhaust will help you out.

And I really can't make out that last question there, maybe reword it somehow.