|
i got the new apc litestripes for the outside of your car and the directions are confusing as hell.. i was wondering if i put the directions on here would one of you be able to translate this better for me so i c an understand it...maybe some pictures..thanks
1.mount each litestripe first, then press protective liner to desired location
2. carefully route ribbon wire from lightstripe to power supply location
3. locate 12 volt hot lead on any running light( i have no clue where these are) install T tap onto red wire and plug into hot lead tap( what would it be)
4. secure pink connector to power supply red lead
basically it says you can cut them to any desired location but i dont get how they would still light. i dont have any pics but you can go on ebay motors and look at them. its basically hard as hell for me to figure out so hopefully someone can help me a little. thanks
|
Threaded Mode