Yo guys, Here is my exhaust pictures and all. This is a follow up post from a previous one. (
http://invision.aleromod.com/index.php?showtopic=18099)
A few members where wondering what custom exhaust I got done. I went into Mienkee and asked for custom exhaust, mandrel bent 2.5 inch. They told me that a Y setup would be great. And that they would come off the cat, and then go to a muffler and then two outlets. (Y Setup). They used a Vortech Muffler and I had them remove the resonator.
Here are some pictures. I got this exhaust about 4 years ago. And I am not sure what type of piping they ended up using, i know its 2.5 inch. Can someone tell me what kind it is? And why it rusted so much? It is my daily driver. BUT MY MAIN QUESTION IS, IS THERE ANYTHING I CAN PUT ON IT, OR SPRAY TO HELP COVER THE RUST OR TO STOP IT FROM RUSTING THROUGH. So far it has not rusted through and is pretty soild. PLEASE REMEMBER THIS WAS DONE ON A HIGH SCHOOL STUDENTS LIMITED BUDGET[b]. At the time. Here are the pictures:
Starting at the Cat:
Moving on we see the pipping they used, any idea what material it is?
Here it bends toward the driver side:
Now it goes up and over the Suspension:
Now this is from behind the car, the rear, looking back at where it came over the suspension:
The Muffler, and two Outlets:
Threaded Mode