|
well i blew my factory 6x9's a few months ago and finally decided to get off my butt and start upgrading the sound system. i decided to just start with a pair of alpine 3 way 6x9's and add an amp next week. and grow from there.
i picked up the alpines today and after tearing apart the back seat i realized it had 4 wires instead of two. i remember when i was doing soem research that circuit city had a harness, so i headed there only to find it was the wrong harness i was looking at and they were out of stock on the one i need. after showing them the speaker they said i may be able to just use the two wires from the harness that supply the signal to the cone (as opposed to the 2 that supply the signal to the tweeter) and it may work just fine or i may loose all highs in the rear. if not i could go with the audiobahn 6x9 that does take all 4 wires (but i have read some bad reviews on these).
does anybody have any suggestions that i can do with this or am i going to have to replace the system and have it all rewired? any help is appreciated and thanks.
|
Threaded Mode