Ashtray Art

[cherrington17]

finally got around to starting this... man its been a while...

starts as...

[cherrington17]

after attacking it with a dremel... (painted the emblem on there w/ white first.... you can still see a little bit of it)

[cherrington17]

and last pic of the first stages....

i'm waiting for some epoxy to dry, then i'm gonna paint it black, a coat or two of clearcoat to seal it, then epoxy the symbol in clear.

lastly, i gotta put 1-2 blue leds in the bottom and connect them in, so the symbol glows. this so far, was soo much easier then that biohazard sign i have.... :lol:

[smlzalero]

looks like crap, lol :P jk

So you're gonna fill in the symbol? What kind of epoxy are you using? I hope it doesn't cure yellow..

And you are going to trim it so it's a smooth design.. right?

[nex]

:wtf: :wtf:

[cherrington17]

yes, i did smooth it out. and the epoxy will be clear. i've used it for a ton of things and its never been anything but clear.

(if it turns out like crap i'll just scrap the project) lol

[cherrington17]

and there are a few points where its still connected.. those will be fixed. if you don't leave a few like that the center pieces will fall right out.... after the major epoxy dries, i'm gonna trim those out and fill in again...

[smlzalero]

lol, ok. Just making sure... that would be nasty to have a pea-green olds symbol.. lol

[Crolero]

looks good, nice idea. should look even better when done :thumb: