Aleromod.com - Alarm Problem??

Aleromod.com (http://www.aleromod.com/forums/forum.php)

- Common Questions & Troubleshooting (http://www.aleromod.com/forums/forumdisplay.php?f=17)

- - Alarm Problem?? (http://www.aleromod.com/forums/showthread.php?t=17066)

Mr_Reed

03-20-2007 09:59 AM

Alarm Problem??

Well I'm a little pissed off and disapointed in my Alero..
As of right now..
My Windows don't roll down.
My Lower Intake Manifold Gasket has a small leak.
My Fog lights don't work.
My Turn Signals have a mind of their own..
And now my newest entry is that my Alarm on my car is being retarded. I'm not sure whats setting it off but all I know is that it shuts off the fuel to my motor when its triggered I half to put the Key in the ignition for 10 minutes until the security light goes out than it will start but I'm getting tired of doing that anyone else ever had a problem with their Alarm?

alero168

03-20-2007 11:15 AM

if youre talking about the passlock then you might need a new key cut, take it to a locksmith too not walmart

AGT	03-20-2007 11:19 AM

Quote:

Originally Posted by Mr_Reed (Post 265618)

Fogs-Did you check the bulbs yet?

Alarm-Do you ever turn your car to the ON position and then turn it back before you start it...I just ask because I used to and the security light would come on. Only way for it to go off way to tunr off and back on

Mr_Reed

03-20-2007 11:35 AM

Quote:

Originally Posted by AGT (Post 265630)

Fogs-Did you check the bulbs yet?

Yes, the assembly messed up I need to replace the hole light..Its all good though.

Alarm-Do you ever turn your car to the ON position and then turn it back before you start it...I just ask because I used to and the security light would come on. Only way for it to go off way to tunr off and back on

Yeah but if I do that and than turn the car off and back on the car won't start.
I half to wait 10 minutes the the key on than when the light goes off it will start.

alero168

03-23-2007 06:29 PM

you need to cut a new key

steve-o

03-23-2007 06:52 PM

Quote:

Originally Posted by alero168 (Post 266754)

you need to cut a new key

Can you just get a new key cut? I though you had to replace the whole ignition.

Gr1m	03-23-2007 07:08 PM

the thing that is causing your signals acting up is the hazard light switch (red button with a triangle in your dash) if you wiggle the button around with your turn signals on you will see what i mean, just put it into a place where it doesnt act up, or just get the hazard switch replaced

alero168

03-27-2007 11:16 AM

Quote:

Originally Posted by steve-o (Post 266765)

Can you just get a new key cut? I though you had to replace the whole ignition.

not new key as in a different set of keys but just freshly cut of your original keys... this topic has been talked about before, a search should pull up what i'm talking about.

All times are GMT -4. The time now is 12:12 PM.