After having the box built in the back seat i decided to tear it out. I wanted to move my audio back to the trunk and downsize on power i wanted to loose my 3 Kinetik 1800's Pioneer 15" TS-W8102SPL, 8 cube box, and the soundstream XXX10K, i striped out the audio and replaced my back seats. after that i ran an 8" MTX thunder 5500 and a pioneer 300W amp. This weekend i got back an old setup i sold to a girl. it's a 15" Cerwin Vega V-Max Dual4 wire to 2 ohms. the amp is a 2003 series rockford fosgate 500bd. for my front stage anp i left in my rockford fosgate 160aII and replace the rear stage alpine amp for a 500a2 i was given from a dealer, i had to take it apart and repair the remote turn on due to the ripped out connection. then i added 5 layers of dynomat to the trunk lid insert that rattles so badly. This setup is temporary but i figured i would post some pictures up to show my project. here is a link below of my prior build log from
www.caraudio.com.
build log:
http://www.caraudio.com/forum/showth...=390087&page=3
competition Log: In signiture.
theres how it was when i hit my best 146.7dB at the windsheild sealed.
trunk board out.
stripped trunk.
stripping out the seals
box ready to be pulled out just have to take the door off.
the mess.
all done.
