Aleromod.com - View Single Post - replacing PS steering hoses and PS pump valve

falloutboy · 11-12-2010, 07:35 PM

thanks

About the valve. I just read somewhere that there are problems with the the wrong valve being installed while on the assembly line, I just wanted to check if this mismatched valve could cause a loose and / or too easy feeling in the steering (wheel).

You wouldnt happen to know if the later 4cyl cars have the same hoses??? cause there is one wrecked Alero on the other end of Germany - perhaps I'll give it a try. But most times, its cheaper to get new stuff from the US.

11-12-2010, 07:35 PM	#3
falloutboy GL Member Join Date: Aug 2005 Location: Grafenberg, Germany Posts: 826	thanks About the valve. I just read somewhere that there are problems with the the wrong valve being installed while on the assembly line, I just wanted to check if this mismatched valve could cause a loose and / or too easy feeling in the steering (wheel). You wouldnt happen to know if the later 4cyl cars have the same hoses??? cause there is one wrecked Alero on the other end of Germany - perhaps I'll give it a try. But most times, its cheaper to get new stuff from the US. __________________ My round trip through the US of A Thanks Julian 1979 350SB Chevrolet Camaro Project Thread 1995 Chrysler Stratus LX 1999 3.4L Oldsmobile Alero (resource page) 2002 Nissan Primera with CVT Visit my garage