Gauge Pod Is In

[Redog]

actually with the EGT you don't need the a/f gauge. the EGT is a lot better

D'ohh (smacks head)

that looks so hitech, where is it from, was it hard to install, how much did it cost, How much do the guages cost? i'm runnin outta interior mods to do. thanx

I got the a/f from Nopi.com and the EGT from Summitracing.com. The install was easier than I though.

I followed the directions on PFYC.com for the pillar install. Then I just ran the wires though the holes in the pod, down the bottom of the pod and over the panel above the pedals to the radio. (Panel comes out real easy. The left panel has a push pin and the right one has 3 7mm bolts)

Hooked up to the wires up to radio hardness. The brown wire is to the lighting, and the yellow is the ingtion wire. These wires are on the right side of the hardness. There is another set of brown and yellow on the left side of the radio but they are speaker wires.